Switching The Display Of The Added Outdoor Sensors; Adding An Outdoor Sensor - Auriol 427197 2301 Assembly, Operating And Safety Instructions

Operation
● Switching the display of the added outdoor
sensors
Note: The automatic channel change function switches between the channels of the
connected outdoor sensors every three seconds.
□ Press the CH button 20 .
The channel display 43 changes the outdoor sensor channel (1, 2 or 3) with
every push of the button and activates the automatic channel change function
with another push of the button ( 42 is shown on the display).
If you have assigned the outdoor sensor to the selected channel, the outdoor sensor data is
displayed.
● Adding an outdoor sensor
Note: You can connect up to three outdoor sensors to the radio-controlled weather station.
Additional outdoor sensors are available from the order service.
□ Briefly press the CH button 20 .
The radio channel switches. The currently selected channel is displayed in the
channel display icon 43 .
□ Open the battery compartment 24 on the back of the outdoor sensor by sliding the
battery compartment lid 25 in the direction of the arrow.
□ Use a thin object for assistance.
□ Set the channel selection switch 23 to the same channel.
□ Keep the CH button 20 depressed until the RF signal icon 59 lights up.
□ Use a thin object for assistance.
□ Press the TX button 22 to establish the connection manually.
Connection is established. The temperature and air humidity are displayed
on the radio-controlled weather station and on the outdoor sensor.
□ Close the battery compartment 24 on the back of the outdoor sensor by sliding the
battery compartment lid 25 counter to the direction of the arrow.
22 GB