Start-Up; Setting Up The Products; Starting The Outdoor Sensor / Changing Batteries - Auriol HG02832 Series Operation And Safety Notes

Start-up

Note: First insert the batteries in the outdoor sensor, then the
main station.

Setting up the products

ATTENTION: First start the outdoor sensor, then the main station.
If possible, do not expose the outdoor sensor or main station to
direct sunlight. Plane it to a horizontal, level surface or mounting
on the vertical wall.
The main station can be hung by the eyebolt
stand to place it on a horizontal, level surface.
6
Starting the outdoor sensor /
changing batteries
Open the battery compartment
sensor by sliding the battery cover
When changing batteries first remove the old batteries.
Insert the new batteries, type LR06, in the battery compartment
Check the polarity of the battery during insertion. This is indicated
in the battery compartment.
Close the battery cover.
The signal LED
light up. The signal LED will then flash about twice a minute,
indicating wireless transmission.
at the front of the outdoor sensor will briefly
17
4
on the back of the outdoor
21
in the direction of the arrow.
18
or flip out the
21
GB/IE 39
.