Panasonic DMR-E20 Operating Instructions Manual page 86

You can limit play of DVDs unsuitable for some audiences. Play and Change these settings when you have connected equipment
changes to the settings are not possible unless you enter a through this unit's OPTICAL DIGITAL AUDIO OUT terminal.
password.
When setting ratings l
The password screen is shown when you select levels 0 to 7.
1. Input a 4-digit password with the numbered buttons.
oil you enter a wrong number, press [CANCEL] to erase it before
you press [ENTER[.
Do not forget your password.
2. Press [ENTER].
3. Press [ENTER].
The password is entered and the unit is locked.
I ow, when you insert a DVD-Video that exceeds the ratings |
limit you set, a message appears on the television.
J
Follow the on-screen instructions.
changing ratings j
When
PCM Down Conversion
Off (factory setting):
When you have used audio cables to connect the unit to other
equipment (analog connection [] =o page 78).
On:
When you have used an optical digital cable to connect the unit to
other equipment (digital connection r_ = page 78). Output is limited
to 48 kHz/16 bit.
Output of audio with a sampling frequency of 96 kHz
Audio is output as follows in accordance with the connections and
settings you make.
(digital) (analog)
Off No output "_ Output as 96 kHz
On Converted and output Converted and output
as 48 kHz/16 bit as 48 kHz
_ 96 kHz audio is output if the DVD is unprotected, but the connect-
ed equipment must be able to handle such signals in order to play
them.
J Dolby Digital I
I [
==
The password screen is shown when you select "Ratings".
1. Input your 4-digit password with the numbered buttons and press
[ENTER].
Unlock Recorder: To unlock the unit and return the rating to 8
Change Password: To change your password
Change Level: TO change the rating level
Temporary Unlock: TO temporarily unlock the unit (the unit
locks again if you switch it to standby or
open the disc tray)
2. Select the item with the joystick [A, "] and press lENTEn I.
Actual screens depend on the operation. Follow the on-screen
instructions.
Bitstream (Factory preset):
When you have connected a unit with a built-in Dolby Digital
decoder.
PCM:
When you have connected a unit that doesn't have a built-in Dolby
Digital decoder. ,2
DTS
Off (Factory preset):
When you have connected a unit that doesn't have a built-in DTS
decoder, ,,2
Bitstream:
When you have connected a unit with a built-in DTS decoder.
•2 Set "Dolby Digital" to "PCM" and "DTS" to "Off" if the other equip-
ment doesn't have decoders. Incorrect settings can cause noise
to be output which can be harmful to your ears and speakers, and
audio will not be recorded properly to digital recording equipment.
I
T6035