Table of Contents
Advertisement
Chapter Objectives
Installing the AEC
Complying with European
Union Directives
11
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Installation & Hook-Up
Read this entire chapter before beginning to mount, connect, or wire
any of the components to the AEC. It is the responsibility of the
installer to see that the installation conforms to the directions in this
manual and local codes and procedures. This chapter covers the
following topics.
• European Union Compliance
• Mounting the AEC.
• Connecting the AEC to the 1394 GMC system.
• Connecting the AEC to the Compact motion controller.
• Connecting the AEC to the 1746-MO2AE.
• Wiring the SSI transducer to the AEC.
• Wiring the Control connector.
• An example of a Fault relay.
• Wiring the Power connector.
The AEC is designed to mount in an electrical cabinet using the
flanges on its back panel. This installation method should be observed
for all applications. Before powering the AEC, make sure it has been
configured correctly and that the transducer(s) and control devices
(controller) are connected to it correctly.
The information contained in this document pertains to the Absolute
Encoder Converter (AEC), an Allen-Bradley product. If the AEC is
installed within the European Union or EEA regions and has the CE
mark, the following regulations apply.
2
Chapter
Publication 4100-5.2 - March 2000
Advertisement
Table of Contents
