Process" Parameters; Rod Electrode Welding; Tig Welding - Fronius Trans Pocket 4000 CEL Operating Instructions/Spare Parts List

"Process" parameters

Rod electrode The function HCU (Hot-start current) and the available setting range are explained in the
welding section "Rod electrode welding".
HCU
Hot-start current - 0 - 100 %
Factory setting: 50 %
The function HCU (Hot-start current) and the available setting range are explained in the
section "Rod electrode welding".
Hti
Hot-current time - 0 - 2.0 s
Factory setting: 0.5 s
FAC
Factory - Resets the power source to factory settings
Press and hold the Setup / Store button (7) for 2 s to reset the machine to its original (i.e.
factory) settings. If the display reads "PrG", then the power source has been reset.
The reset functions in the Second Level of the Setup Menu (2nd) are not deleted either.
2nd
Second level of the set-up menu (see the section headed "The set-up menu: Level 2")

TIG welding

2nd
Second level of the set-up menu (see the section headed "The set-up menu: Level 2")
NOTE! When you reset the power source, all personal settings are lost in Level
1 of the Setup Menu.
26