Operating Procedures (Quick Auto Stop Operation) - Yamato IC103CW Manual

Used when you want to "stop fixed temperature operation being performed automatically in several
hours. Quick auto stop operation is a function to enable auto stop timer setting during operation.
Procedures for quick auto
stop operation
MEASURED TEMP.
HEATER
RUN
SET TEMP.
TIMER
SUB MENU
①
About the timer function
MEASURED TEMP.
HEATER
RUN
SET TEMP.
TIMER
SUB MENU
MEASURED TEMP.
HEATER
RUN
SET TEMP.
TIMER
SUB MENU

Operating procedures (quick auto stop operation)

1. Setting time period before stop during fixed
temperature operation
① Make sure that the RUN lamp is illuminated to
℃
RUN
STOP
②
② Set a duration you want using the ▼▲ keys.
The maximum time that can be set for the timer is 999 hours
50 minutes.
Up to 99 hours 59 minutes, time can be set in minutes.
One hundred hours and over are set only in 10 minutes.
Keep the ▼▲ keys pressed to continuously change set
time and you can quickly reach the time you want. Press the
▼▲ keys once at a time for fine adjustment.
2. Starting timer operation
When the time you want is set, press the RUN/STOP key
while the set temperature screen is blinking.
℃
The RUN lamp blinks and timer operation is started.
Timer starts counting when the temperature in the
RUN
chamber reaches the set temperature.
STOP
Once timer counting is started, the set temperature screen
changes to the remaining time display.
3.Stopping and ending timer operation
Operation stops automatically when the set temperature
has elapsed.
℃
Characters End
screen to indicate operation has ended.
RUN
STOP Press the RUN/STOP key for approx. one second to end
the timer operation mode. The screen switches to the
initial setting screen.
4. Operating procedures
indicate the unit is in operation.
Press the TIMER key.
Characters AStP
measured temperature screen to indicate the auto
stop operation mode and set duration blinks on the
set temperature screen.
blink on the set temperature
21
are indicated on the