Table of Contents
Advertisement
When you want to correct
set temperature or set time,
or change settings
4. Operating procedures
Operating procedures (auto stop operation)
When you want to change settings, press the ▼▲ keys on
the current screen to enter the setting mode where you can
change settings. Blinking stops three seconds after change
and setting is completed. Note, however, that temperature
changes after timer activation are counted also while
temperature is changing.
When you want to change settings before timer activation,
press the TIMER key on the current screen to enter the
setting mode where you can change settings. Enter a time
duration from when the set temperature is reached to the
time the device shall be stopped.
When you want to change settings after timer activation,
press the TIMER key on the current screen to enter the
setting mode where you can change settings. Note,
however, you need to set a time calculated by adding the
time already passed to the time to be added.
After change has been made, press the RUN/STOP key to
complete the process.
Auto stop operation is not available together with auto start
operation.
When you want to stop auto stop operation in the middle of
it, press the RUN/STOP key long once to stop device
control once, and then make settings again in the
appropriate mode.
In terms of the remaining time display
dot indicates count down and an illuminating dot indicates a
wait status (while temperature is increasing or decreasing to
the set temperature) during which the timer has stopped
counting.
24
a blinking
Advertisement
Table of Contents
