Table of Contents
Advertisement
19) Build the project by clicking on the Hammer icon in the toolbar
20) Click Run->Debug Configurations... in the menu bar, and select the
QSD_twrK60D100M_Int_Flash_Debug_PnE U-MultiLink configuration. Then hit the debug
button in the bottom of the window
21) If this is the first time you've used CW10.4 with your board, you may get a dialog box asking to
update the OSJTAG firmware. Unplug your board, put a jumper on J19 which is labeled JM60
Boot, and plug the board back in. Hit "OK" on the dialog box, and the board OSJTAG firmware
will update. When it is done, unplug the board, remove the jumper on J19, and hit "OK" again
on the dialog box. If you do not have a spare jumper, you can temporarily use the one on J9.
22) The code will then be flashed to the board and the debugger started.
23) Once the code is done flashing, the code will pause at the starting instruction of the MQX.
24) Hit the run icon to continue the program execution.
5.2 IAR Embedded Workbench for ARM 6.50.6
1) Follow the directions in
OSJTAG Troubleshooting.
2) Install IAR for ARM v6.60 or higher. The Evaluation edition or Full edition will be required
because of code size.
3) Install MQX 4.0. You can find this on the
Section 3
to update the OSJTAG firmware and drivers. See
MQX website
TWR-K60D100M Quick Start Demo Lab Guide
Section 9
for
Page 11 of 19
Advertisement
Table of Contents
