Codewarrior For Microcontrollers 10.4 - Freescale Semiconductor TWR-K60D100M Quick Start Manual

Table of Contents

5.1 CodeWarrior for Microcontrollers 10.4

1) Follow the directions in

OSJTAG Troubleshooting.

2) Install CodeWarrior for Microcontrollers 10.4. The Evaluation edition or Standard version or

higher will be required because of code size.

3) Install any CodeWarrior patches available.

4) Install MQX 4.0. You can find this from the

5) You must then compile the MQX libraries for the TWR-K60D100M board. The workspace at

<mqx_dir>\config\twrk60d100m\cw10\twrk60d100m.wsd has all the libraries to build and

can be imported going to the File->Import and then Other->Import Working Sets.

6) Click on the Build All button to re-compile all the K60 libraries.

Use the default "Debug" targets. See the Getting Started with Freescale MQX™ RTOS

document in the <mqx_dir>\doc folder for more information if needed on compiling the

libraries before continuing on with the lab.

Section 3

to update the OSJTAG firmware and drivers. See

MQX website

TWR-K60D100M Quick Start Demo Lab Guide

Section 9

for

Page 8 of 19

Table of Contents

Do you have a question about the TWR-K60D100M and is the answer not in the manual?