Display Brightness; Acoustic Signal - Sartorius SECURA3101-1CEU Operating Instructions Manual

System Settings (Setup Menu)

Display brightness

Bright
Medium
Eco Mode

Acoustic signal

Loud
Medium
Low
Off
38
User Manual Secura ® , Quintix
2) Connection with Sartorius lab printer via the supplied printer cable
Device / Protocol
Select the desired setting for connection to the printer .
t
YDP30 | YDP40
–
connection is established .
Off
– : The connection to the printer is deactivated .
3) and 4) Connection to a serial printer or another external serial device via a
9-/25-pin serial interface (USB Mini A for RS-232)
Device / Protocol
Select the desired setting for connection to the device .
t
– Printer YDP20-0CE
– Second display YRD03Z
USB-RS-232 SBI
–
USB-RS-232 xBPI
–
Off
– : The connection is deactivated .
RS-232 Configuration
This option can be selected by going to
USB-RS-232 SBI
Select the desired setting for the RS-232 interface .
t
Baudrate
–
Databits
–
– Parity : Odd, Even, or None (default: Odd)
– Stopbits
– Handshake
[default: Hardware (CTS, RTS)]
6.2.9 Display Brightness
l
Set the display brightness here .
The following brightness levels are available:
Bright
–
– Medium
– Eco mode : energy-saving mode (default) . Brightness is reduced after two
minutes of inactivity . Press any key to return to normal brightness .
6.2.10 Acoustic signal
l
Set the volume of the acoustic signal here .
The following volume levels are available:
Loud
–
Medium
–
– Low
– Off
® , Practum ®
menu option:
: The connected printer is automatically detected and the
menu option:
(Secura ® and Quintix
menu option:
Device / Protocol
setting .
: 600 to 19,200 (factory setting: 9600)
: 7 Bits or 8 Bits (default: 8 Bits)
: 1 Bit or 2 Bits (default: 1 Bit)
: Software (XON, XOFF), Hardware (CTS, RTS), or Off
® only)
and choosing the