Assembly - WAGO 751-5201 Manual

2.1.1.8 Assembly

1. Mount ground plate on an even surface (machine frame or mounting plate)
2. Place the cables in the cutouts that are marked for this purpose. Make sure
3. Fix the upper part in the snap-in position in the ground plate.
4. Push the upper part onto the ground plate. Tighten screws in the upper part
Fig. 2.1.1-8: Assembly
WAGO-I/O-SYSTEM 751
AS-Interface Components IP67
751-5201 [AS-Interface Module 4IN/4OUT 24V/2A Single]
using sufficiently long M4 cheese-head screws
that the cables engage behind the locking latch. For modules with unused
AUX socket, insert the enclosed blanking cap to seal the cable entry.
with a tightening torque of 0.9 Nm. Electrical contact with the conductors
is made automatically.
.
• 17
Assembly
gqxxx10x