Table of Contents
Advertisement
Activate the System
WARNING:
components should be operated and maintained by trained personnel only.
WARNING:
scenery.
Machinery must only be operated from a line-of-sight position. The entire
load must be visible by the operator at all times during travel.
To enable the station for motor control, insert the key into the POWER key
switch and turn it to the ON position.
During power up, the control system performs a complete self-test of the
control station and all connected motors. When the station has powered up
completely and no malfunctions were detected, System OK appears on the
screen.
Contact Information
The contact information screen is shown as the system powers up. This screen displays contact
information for the installer responsible for the system or the ETC website and phone number.
Your installer may have chosen to display their contact information. The software version is
also displayed during the start up.
By default, this contact information is displayed for three seconds. To prolong the display of
contact information indefinitely, press and hold [Clear] during power up. The contact
information will be displayed until any other button is pressed. You can also allow the
controller to time out and the information will be displayed again.
Deactivate the System
When you are done using your control station, or when you will be leaving it
unattended for any length of time, deactivate the station using the POWER
key switch.
Turn the key switch to the OFF position and remove the key. The station will
be deactivated.
Emergency Stop
An emergency stop (E-stop) button stops all movement for all system motors in the fastest
possible way and deselects all motors. Once pressed, the E-stop button is maintained in an
activated position until it is reset.
It is possible to have multiple emergency stop buttons in your ETC Rigging system:
8
QuickTouch+ control stations and other ETC Rigging
Do not move load into people or other obstacles such as
QuickTouch+ Mk2 User Guide
Advertisement
Table of Contents
