Reliance electric GV3000 Instruction Manual page 89

Appendix C
Compliance with EN 60204-1: 1992
The GV3000 complies with the following sections of standard EN 60204-1: 1992.
EN60204-1
Section Title
6 Protection against electrical shock
6.2.1 - Protection by enclosure
6.2.3 - Protection against residual voltages
6.3.1 - Protection by automatic disconnect of supply
6.4 - Protection by the use of PELV (Protective Extra Low Voltage)
7 Protection of equipment
7.2 - Overcurrent protection
7.2.3 - Control circuits
7.2.6 - Transformers
7.5 - Protection against supply interruption or voltage reduction and subsequentrestoration
8 Equipotential bonding
8.2.1 - General (the PE terminal)
8.2.2 - Protective conductors (connection points)
8.2.3 - Continuity of the protective bonding circuit
8.2.7 - Protective conductor connecting points
8.3 - Bonding to the protective bonding circuit for operational purposes
8.4 - Insulation failures
8.5 - Bonding to acommon reference potential
8.6 - Electrical interferences
9 Control circuit and control functions
9.1.1 - Control circuit supply
9.1.3 - Protection
9.1.4 - Connection of control devices
9.2 - Control functions
9.2.1 - Start function
9.2.2 - Stop function
9.2.3 - Operating modes
9.2.5 - Operation
9.2.5.3 - Stop
9.2.5.6 - Hole-to-run controls
9.2.6 - Combined start and stop controls
9.3 - Protective interlocks
9.3.5 - Reverse current braking
9.4 - Control functions in case of failure
9.4.2.1 - Use of proven circuit techniques and components
9.4.3 - Provisions for redundancy
9.4.3.4 - Earth faults
9.4.3.2 - Voltage interruption
C-1