Reliance electric GV3000 Instruction Manual page 60

Table 7.1 - Wiring Signal and Control I/O to the Terminal Strip (Continued)
Terminal
Number Description Parameters/Wiring Connections
Wiring an Additional Ramp Input
18 Digital Input 7 Digital inout 7 is control function programmable through
(Default - Ramp1/Ramp2)
parameter P007. The following parameters must be set:
PO00: Control Source
P001: Accel Time 1 (Ramp 1)
P002: Decel Time 1 (Ramp 1)
PO06: Second Menu Password
P007: Terminal Strip Digital Inputs Configure (Selects
and assigns a control function to digital inputs
6 to 8).
PO008 Terminal Strip Speed Reference Source (Analog,
Motor Operated Potentiometer (MOP), or
Preset Speeds)
P017: Accel Time 2 (Ramp 2)
P018: Decel Time 2 (Ramp 2)
Note that based on the settings of parameters POOO, P007,
P008, and 1.030 if an RMI board is used, the following
parameters can affect digital input 7.
P.023: MOP Accel/Decel Time
P024: MOP Reset Configuration
P031 to R038: Preset Speeds 1-8
Refer to the GV3000 Programming instruction manual
(D2-3339) for additional information.
16 18
RAMP 1
RAMP 2
Terminal 18 On = Ramp 2
Diagram showsfactory setting.