Table of Contents
Advertisement
BF175AK3/BF200AK3/BF225AK3/BF250A
SERVICE RULES
• Use Honda-recommended lubricants or their equivalents.
• When torquing bolts or nuts, begin with larger-diameter or inner bolts first and tighten to the specified torque
diagonally, unless a particular sequence it specified.
• Lubricate any sliding surfaces before reassembly.
• After reassemble, check all parts for proper installation and operation.
• Metric bolts, nuts and screws are not interchangeable with non-metric fasteners. The use of incorrect tools and
fasteners will damage the unit.
• Hold the connector body to disconnect the connector. Do not disconnect by pulling the wire harness. To disconnect
the locking connector, be sure to unlock first, then disconnect.
• Check the connector terminals for bend, excessive extrusion, missing terminal, or other abnormalities before
connecting the connector.
• To connect, insert the connector as far as it goes. If the connector is a locking type, be sure that it is locked
securely.
• Check the connector cover for breakage and check whether the connector female terminal is not open excessively.
Then, connect the connector securely. Check the connector terminal for rust. Remove the rust using an emery
paper or equivalent material before connecting the connector.
• Set the harness clips in the specified places securely, and secure the wire harness.
• Clamp the cables securely.
• Clamp the wire harnesses securely sot that they do not interfere with the rotating parts, moving parts and the hot
parts.
• Route and connect the wire harnesses properly. Be sure that the harnesses are not slack, twisted or pulled taut.
• Route the wire harnesses properly sot that they do not contact with the sharp edges and corners, and the end of
the bolts and screws on the body.
• If a wire harness contacts the end of the bolts/screws or sharp edges and corners, protect the contact part of the
wire harness with a tube or by winding with electrical insulating tape. If the wire harness has a grommet, set the
grommet securely.
SYMBOLS
The symbols used throughout this manual show specific service procedures. If supplementary information is required
pertaining to these symbols, it would be explained specifically in the text without the use of the symbols.
x
( )
page 1
4
Use marine grease (water resistant urea based grease).
Indicates the diameter, length, and quantity of bolts used.
Indicates the reference page.
Advertisement
Table of Contents
