Table of Contents
Advertisement
BF175AK3/BF200AK3/BF225AK3/BF250A
Set the wire harness clip (1) to the harness bracket (2).
(1)
Install the harness bracket by aligning its cutout (3) with the
(2)
crankcase boss.
Install and tighten the bolt (4).
(4)
(3)
Make sure the white mark (1) on the starter cable (2) aligns with the
edge of the front cover bracket (3).
(1)
(2)
Pass the fuel tube (4), indicator panel wire harness (5), starter
cables (6), switch panel wire harness (7) through the under case
grommet A (8).
(3)
(2)
(3)
(8)
(5)
(4)
(7)
(6)
Position tie-wrap bands (1) on the switch panel wire harness and
indicator wire harness at the inside of the under case grommet A
(2).
(1)
(2)
19
Advertisement
Table of Contents
