Table of Contents
Advertisement
Set the switch panel wire harness into the crankcase groove.
Set the two wire harness clips (1) to the harness bracket (2).
Install the harness bracket by aligning its cutout (3) with the
crankcase boss (4).
Install and tighten the bolt (6 x 14 mm) (5).
Make sure the white mark (1) on the starter cable (2) aligns with the
edge of the front cover bracket (3).
Pass the fuel tube A (4), indicator panel wire harness (5), starter
cables (6) and switch panel wire harness (7) through the under case
grommet A (8).
Install the under case grommet A (1) to the groove (2) of the front
cover bracket as shown.
Install the remote control cable plate (3) to the groove (4) of the front
cover bracket and tighten the bolt (6 x 16 mm) (5).
BF175AK3/BF200AK3/BF225AK3/BF250A
(1)
(2)
(5)
(1)
(2)
(3)
(4)
(5)
(1)
(4)
(3)
(1)
(2)
(3)
(8)
(5)
(7)
(6)
(3)
(4)
(2)
21
Advertisement
Table of Contents
