Table of Contents
Advertisement
BF175AK3/BF200AK3/BF225AK3/BF250A
Install under case grommet A (1) to the groove (2) of the front cover
bracket as shown.
Install the remote control cable plate (3) to the groove (4) of the front
cover bracket and tighten the bolt (5).
Install the shift control cable (1) and throttle control cable (2) by
aligning their grooves (3) with the grooves in the cable plate.
Put the remote control cables in under case grommet A.
Set the grommet band (1) and tighten the screw (2). Make sure the
fuel tube is not pinched by the grommet.
CABLE/WIRE ROUTING (BF250A)
• Be careful not to press the fuel tube A with the under case
grommet A.
Connect the switch panel wire harness connector 14P connector (1)
and indicator panel wire harness 6P connector (2), and then attach
them to the connector holders.
20
(5)
(1)
(1)
(3)
(1)
(2)
(3)
(4)
(2)
(2)
(2)
(1)
Advertisement
Table of Contents
