Table of Contents
Advertisement
BF175AK3/BF200AK3/BF225AK3/BF250A
9. With the shift side cable in the condition described in step 7,
connect the shift control cable (1) to the shift link (2) while turning
the shift pivot so the shift pivot sets on the shift link smoothly.
Take care not to move mark (C) and outer seal end out of align-
ment. Hold the shift link at the center of the play.
Lock the lock plate (3) by sliding it to the groove of the shift link.
10.Make sure the detent roller (1) is in the shift arm groove (2) and
detent spring tip (3) to the neutral switch (4) pushed at shift to the
neutral position.
11.After connecting the cable, move the remote control lever back
and forth and check for proper shifting.
If it is hard to put the remote control lever in the "F" (Forward) or
"R" (Reverse) position with the engine stopped, shift the gear
while turning the propeller or propeller shaft. Do not shift the gear
with force, or damage to the shift system can result.
12.If the gear is not in neutral by moving the remote control lever
from the "F" (Forward) to the "N" (Neutral) position, remove the
shift side cable and move the inner cable toward the mark (A) (1).
Repeat the procedure from the step 8.
24
(1)
(3)
(1)
ADJUSTMENT
RANGE
(1)
(2)
(2)
(3)
(4)
Advertisement
Table of Contents
