Table of Contents
Advertisement
Propeller Installation
• Disconnect the battery cable terminal to prevent the engine from
starting accidentally.
• Wear heavy gloves to protect your hands from sharp or nicked
propeller blades.
Apply marine grease to the propeller shaft.
Install the thrust washer (1) and the propeller (Not included) (2) on
the propeller shaft.
Install the propeller washer (1) and castle nut (18 mm) (2).
Tighten the castle nut (18 mm) and secure with the split pin (3).
TORQUE: 1 N•m (0.1 kgf•m, 0.7 lbf•ft)
If the split pin does not align with the hole in the propeller shaft,
adjust by turning the nut in the tightening direction. Do not exceed
the maximum torque.
Maximum tightening torque:
44.1 N•m (4.5 kgf•m, 32 lbf•ft)
After installation, bend the split pin (1) ends as shown to secure.
If the commercially available parts are used, select the stainless
steel parts.
BF175AK3/BF200AK3/BF225AK3/BF250A
(1)
(2)
(3)
(1)
(2)
(1)
33
Advertisement
Table of Contents
