Table of Contents
Advertisement
The device operates normally.
¨
14.3.
Functional check
WARNING
Danger of fatal injury as a result of faults in installation and functional check.
Before carrying out the functional check, make sure that there are no persons in the danger zone.
Ì
Observe the valid accident prevention regulations.
Ì
14.3.1. Mechanical function test
The actuator must slide easily into the actuating head. Close the guard several times to check the function. For devices with
mechanical release (emergency release or escape release), the correct function of the release must be checked as well.
14.3.2. Electrical function test
After installation and after any fault, the safety function must be fully checked. Proceed as follows:
1. Switch on operating voltage.
The machine must not start automatically.
¨
The safety switch carries out a self-test. The green STATE LED then flashes at regular intervals.
¨
2. Close all guards. In case of guard locking by solenoid force: activate guard locking.
The machine must not start automatically. It must not be possible to open the guard.
¨
The green STATE LED illuminates continuously.
¨
3. Enable operation in the control system.
It must not be possible to deactivate guard locking as long as operation is enabled.
¨
4. Disable operation in the control system and deactivate guard locking.
The guard must remain locked until there is no longer any risk of injury.
¨
It must not be possible to start the machine as long as guard locking is deactivated.
¨
Repeat steps 2 - 4 for each guard.
14.4.
Factory reset
Before switching on, connect the two outputs FO1A and FO1B to 0 V or set the bit Ox1E via IO-Link communication.
MAN20001654-01-03/23 (translation of the original operating instructions)
Transponder-Coded Safety Switch CTP/CTA-L1/2-BR
Operating Instructions
37
EN
Advertisement
Table of Contents
