Clearing Cutter Jams; Cleaning Adhesive From The Cutter Blade - Tharo Systems V Series User Manual

Clearing Cutter Jams

1. If the Cutter jams or malfunctions turn the
Printer Off.
2. There is a hole (marked "A") on each side
of the Cutter. Insert a 3mm hex key into
one of these holes and turn the cutter
blade clockwise.
3. After the problem is corrected, turn the
Printer back On and the cutter blade will
go back to its original position.
Note: It is recommended to use labels greater
than 35mm (1.38") in height in order for them to
clear the Cutter.

Cleaning Adhesive from the Cutter Blade

When using adhesive labels, the cutter may
malfunction due to a build up of adhesive on
the blade. When this happens it will be
necessary to clean the Cutter Blade:
1. Turn the Printer Off.
2. Remove the Cutter assembly from the
Printer.
3. Wet a cotton swab in Isopropyl Alcohol
and use it to remove any build-ups of
adhesive.
4. There is a hole (marked "A") on each side
of the Cutter. Insert a 3mm hex key into
one of these holes and turn the cutter
blade clockwise to allow access to the
entire length of the blade.
5. Allow the cutter to dry for 10 minutes.
6. Re-install the Cutter assembly and turn
the Printer back On. The cutter blade will
go back to its original position.
33
A