Control Panel; General Description And Operation; Interpreting Led Messages; Printer Setup - Tharo Systems V Series User Manual

6. Control Panel

General Description and Operation

FEED Key
Pressing the FEED key will cause the Printer to advance the media (according to media type) to a
specified stop position. If the Printer is loaded with continuous media the Printer will FEED the media
out a certain length. If the Printer is loaded with labels with gaps or black marks, the Printer will
advance one label at a time. If the label is not sent out in a correct position the sensor must be
calibrated. Follow the instructions for Sensor Calibration in the Maintenance and Adjustment section of
this manual.

Interpreting LED Messages

*If both of READY and STATUS lights are green when doing Auto-Sensing, then the See-through Sensor
is on. If both of READY and STATUS lights are orange, then the See-through Sensor is off.

Printer Setup

By holding down the FEED key and turning the power on, you will be able to change the Printer settings
depending on how many times the beeps before the FEED key is released. When the Printer is first
powered up, the Printer will beep 3 times quickly, and then will beep slowly after that.
Printer Setting
Self Test
Auto Sensing
Dump Mode On
Direct Thermal
Thermal Transfer
See Through Sensor ON
Top of Form ON/OFF
LED
Ready Status
Green
Red
Orange
(Flashing)
Green
Orange
(Flashing)
Orange Orange
Or Or
Green* Green*
Red
(Flashing)
11
Beep Description
1 Normal
The Printer is printing a
Self-Test Label. Refer to
3
Appendix B for more
information.
The Printer is in Dump
3 Mode. Refer to Appendix B
for more information.
Printer is in Auto-Sensing
3 Mode.
The Printer is in firmware
download mode.
Slow Beeps
0 beeps
1 beep
2 beeps
3 beeps
4 beeps
5 beeps
6 beeps