Direct Thermal / Thermal Transfer Mode Switch
To switch into Direct Thermal (DT) Mode:
1. Turn the Printer Off and press and hold the FEED key.
2. Turn the Printer On while holding down the FEED key.
3. The Printer will beep three times. Continue to hold the FEED key down until the Printer beeps
three more times. Release the FEED key after the third beep.
4. The Printer will print, "NOW IS DIRECT THERMAL (DT MODE)". This indicates that Printer is now
in DT Mode.
To switch into Thermal Transfer (TT) Mode:
2.
Turn the Printer Off and press and hold the FEED key.
3.
Turn the Printer On while holding down the FEED key.
4.
The Printer will beep three times. Continue to hold the FEED key down until the Printer beeps
four more times. Release the FEED Key after the fourth beep.
5.
The Printer will print, "NOW IS THERMAL TRANSFER (TT MODE)". This indicates that Printer is
now in TT Mode.
Card / Hang tags Installation
When installing card tags, the tag hole
must align with the sensor arrow (as
indicated), and then use the Label Guide
to secure the tags.
Tag hole position
Sensor Detection Position
17
Sensor