Printer Setup - Tharo Systems V Series User Manual

5. Printer Setup

CAUTION!
When choosing a location for the Printer, ensure that the Printer and
operator remain dry. If the Printer or the operator get wet, serious
injury to the operator or damage to the Printer may occur.
CAUTION!
Make sure that the Printer's power switch is in the "O" or "Off" position
before proceeding with the installation.
1. Plug the lead from the Switching Power Adapter into the Printer's power socket.
2. Plug the supplied power cord into the Switching Power Adapter and then plug the other end of the
power cord into a grounded outlet.
3. Select the correct cable for the chosen interface. The Printer can be directly connected to the PC in
one of 3 ways: USB, parallel, or serial. For the connection to the USB port use a suitable USB
cable. For the connection to the PC's parallel port use a suitable parallel interface cable. If the serial
interface is used make sure the proper serial cable is used. You can find pin assignments and
descriptions for all three interfaces connectors in Appendix A.
NOTICE!
For Serial communications make sure that the Serial Port Settings in the
Printer are configured the same as in the software you will be using with the
Printer.
4. Connect the Printer to the computer with the selected cable. Then secure the cable using any
screws or clips attached to the connectors. These prevent the connection from working loose.
5. Turn the Printer on, the Ready LED will glow green when the Printer is on.
9