Cutter Module Installation Instructions
1
Cutter Module
2
Screws, Qty. 2
1. Open the Printer's top
cover by pressing the
Open Cover Buttons on
both sides.
2. Release the Print
Mechanism by pushing
in on the Head
Latches. The Print
Mechanism will now
rotate up.
3. The Front Cover Panel
has two tabs, one on
each side. Push these
in to release them and
then remove the Front
Cover Panel as shown.
4. To the right you will
see two sockets.
Choose the socket that
has the same number
of pins as the
connector on the
Cutter Module. Plug
the connector into that
socket.
1
21
2