Table of Contents
Advertisement
8. Installing the Printer's Optional Accessories
The Optional Stripper Sensor Module, Cutter Module, or Compact FLASH Card Slot module with
Real-Time Clock can be easily installed and configured in the field.
component list and installation instructions for these optional accessories.
CAUTION!
Make sure that the Printer's power switch is in the "O" or "Off" position
before proceeding with the installation.
CAUTION!
Unplug the power cord from the Printer before performing any service
on it. Failure to do so could result in personal injury or damage to the
Printer!
V-Series Stripper Sensor Module Installation Instructions
1
Stripper Sensor Module
2
Screws, Qty. 2
NOTE:
The max width
when using the Stripper
Sensor Module is 110mm
NOTE:
Recommended
Label liner thickness
when using the Stripper
Sensor Module is 0.06mm
± 10% with basic weight
65g/
± 6%.
㎡ ㎡ ㎡ ㎡
1.
Open the Printer's top
cover by pressing the
Open Cover Buttons on
both sides.
2.
Release the Print
Mechanism by pushing
in on the Head Latches.
The Print Mechanism
will now rotate up.
1
18
This section will provide a
2
Advertisement
Table of Contents
