Auto Sensing; Turning The See-Through Sensor On/Off - Tharo Systems V Series User Manual

Auto Sensing

Using Auto Sensing the Printer automatically detects and records the label type and length (gap or black
mark paper). Then the Printer can accurately detect the label positions.
1. Adjust the Moveable Sensor so that it is located in a position to sense the label gaps or black marks.
2. Turn the Printer Off and press and hold the FEED key.
3. Turn the Printer On while holding down the FEED key.
4. The Printer will beep three times. Continue to hold the FEED key down; the Printer will beep again.
Then release the FEED key.
5. The Printer will now detect and record the label size/length.
NOTICE!
If both of READY and STATUS lights are green when doing Auto-Sensing,
then the See-through Sensor is on. If both of READY and STATUS lights are
orange, then the See-through Sensor is off.

Turning the See-through Sensor on/off

There are two types of Media Sensor in V-Series Plus Printers – a Reflective Sensor and a See-through
Sensor. By default, the Reflective Sensor is turned on and the See-through Sensor is turned off.
The Reflective Sensor may not be able to detect the label gap on labels with thick liner, colored liner, or
graphics. In these cases the See-through Sensor would need to be enabled.
To turn the See-through Sensor on:
1. Turn the Printer Off and press and hold the FEED key.
2. Turn the Printer On while holding down the FEED key.
3. The Printer will beep three times. Continue to hold the FEED key down; wait for the STATUS light
turn red and READY light flash green, then release the FEED key.
4. The Printer will automatically print "SEE-THROUGH SENSOR IS ON". This indicates that the
See-through Sensor is turned on (and the Reflective Sensor is turned off).
NOTICE!
To turn the See-through Sensor off, repeat above-mentioned procedures.
Then the Printer will print "SEE-THROUGH SENSOR IS OFF" to indicate that
the See-through Sensor is turned off and the Reflective Sensor is now on.
NOTICE!
If both of READY and STATUS lights are green when doing Auto-Sensing,
then the See-through Sensor is on. If both of READY and STATUS lights are
orange, then the See-through Sensor is off.
12