Mounting The Work Piece In The Rotary Attachment - Trotec Speedy 100 flexx Operating Manual

Operation
8.11.4

Mounting the work piece in the rotary attachment

1. Measure the diameter of the workpiece.
2. Adjust the height and angle of the system by loosening and fixing the levers.
Levers for fixation of height and angle
3. Loosen the slider by using the lever in order to clamp the workpiece between the two cones or rolls.
Slider inclusive lever
60
1. The machine must be switched off.
Warning Current
If the rotary attachment is connected
during operation, the connections and the
electronics will be damaged. Such damage is
excluded from the warranty.
2. Place the rotary attachment on the base frame and the
metal pins provided for this purpose using the insertion
handles.
3. Connect the device with the connecting cable via the
connector on the le side of the housing.