Switch Laser Source Manually; Focusing Methods - Trotec Speedy 100 flexx Operating Manual

Operation
8.8

Switch laser source manually

Notice
Only possible for flexx laser systems.
Switching between CO laser source and fiber laser source is done either manually by pressing a shortcut on the control
2
panel, or by making settings in the control soware.
Procedure for manual switching between CO
1) Aer referencing the machine,
press "standby".
8.9

Focusing methods

Precise laser engraving depends on several factors. Apart from the right choice of lens, working tables and a
corresponding exhaust system, correct focusing plays a key role.
The correct setting of the focus, which means the right distance between the laser head and the material to be engraved,
is crucial for a perfect application result.
Manual focus mode
Focus tool
•
Automatic focus modes
Light bar focus
•
Caution
If workpieces with more than 22 lbs (10 kg) have been placed on the table, the table must not be moved
up or down anymore as this might damage the mechanics of the machine.
It is mandatory to focus on the height of the material before loading material of 22 lbs (10 kg) and above.
54
laser source and fiber laser source:
2
2a) Selection: CO laser source
2
Press the marked shortcut
simultaneously to switch to the CO
laser source.
2b) Selection: fiber laser source
Press the marked shortcut
simultaneously to switch to the fiber
2
laser source.