Disassembly - Gree XE71-42/G Owner's Manual

(2) Pull out the 2-core twisted pair wire from the installation hole on wall, and pull
this wire through the "∩" hole at the rear side of the soleplate of wired controller
(3) Stick the soleplate of wired controller on the wall and then use tapping screw
ST3.9×25 MA or screw M4×25 to fix soleplate and installation hole on wall together.
(4) Connect two-core twisted pair wire to H1 and H2 wiring column and then fix
the screws.
(5) Tidy up the wires at the back wire groove of panel and bundle the front panel
of wired controller to its soleplate.
NOTE!
If the procedures in point 2 and point 5 mentioned above is hard to be done as
the diameter of selected communication wire is big, please peel off the sheathed
layer in appropriate length according to actual situation.

5.4 Disassembly

Figure 5-4 Disassembly Diagram for Wired Controller
Wired Controller XE71-42/G
53