Disassembly; Commissioning; Set Master Indoor Unit; Parameter Enquiry - Gree XK49 Owner's Manual

Wired Controller XK49
switch S1 is turned to the "ON" side. Connect the gate-control terminal to the
N and L port or the VCC and GND port. Attention to the following items:
①
The N and L port is the power supply interface of the 100-240V~50/60Hz gate
control.
②
The VCC and GND port is the power supply interface of the DC 5-24V gate
control.
③
Only one power input can be chosen between the 100-240V~50/60Hz and the
DC 5-24V.
(4) After finishing the wiring, set the wired controller soleplate on the wall and use
the M4X25 screws to fix it with the mounting hole.
(5) Insert the wiring on the soleplate to the socket CN1 on the control panel and
then buckle the soleplate and the panel together.

3.1.5 Disassembly

3.2 Commissioning

3.2.1 Set Master Indoor Unit

Under Off status, long press MODE button for 5s to set the corresponding indoor
unit of wired controller as master indoor unit. "MASTER" icon will be light after finishing
setting.
Note:
①
If there is a master indoor unit in a system, other slave indoor units can be set
as master unit, in which case, the original master unit will become a slave unit.
②
In one system, only one set of master indoor unit is allowed. If system detects
that there are several master units, it will designate the unit with the smallest
project number as a master unit.

3.2.2 Parameter Enquiry

Unit parameters can be checked in unit On or Off status.
Fig. 3.15 Disassembly diagram of wired controller
11