When the Indoor Unit detects seven wind speeds the wind speed is set as follows.
Sleep
Speed 1
Three-speeds
When the Indoor Unit detects only three wind speeds the wind speed is set as follows.
Sleep
Speed 1
For the specific IDU series, please consult the technical manual of each series. The following table describes the fan control
in different situations
Fan control in different situations
IDU Status
Operating
Operating
in Set
Standby
Speed
Off
Fault
IDU Status
Operating
Automatic
Standby
Fan Speed
Off
Fault
Note:
Termal: In the heating mode, The IDU in the standby state heating mode will run fan periodically at speed 1 for one minute (the period can be set by controlle)
6.4.2 Auto fan control mode
1. When set auto fan control in cooling or heating mode. After operation in the initial speed for a period of time, when
Thermal ON, IDUs enter the auto mode and the fan speed will be changed every 2 minutes or when Ts change.
2. When Thermal OFF, IDUs enter the standby mode. When Thermal ON, IDUs enters the initial fan speed again.
3. The default speed is speed 1 when IDUs are set auto fan mode in Air supply only mode.