Sinclair SDV 6 Service Manual page 40

4.2 Indoor unit parameter query
Taking SWC-61 as an example
①Hold "
" and "
u00-u03" indicates ODUs, "n00-n63" indicates IDUs (the last two
digits are the ODU or IDU addresses), and "CC" indicates the wired
controller . Press " " and " " to switch the IDU code (For example
n02), then press " " to enter the parameter query page.
②In the parameter query page, use " " and " " to query
parameters, and the parameters can be queried cyclically.
③The check list serial number is displayed in upper right corner of
the wire controller, while the parameter value is displayed in the
middle of the wire controller.
④Press " " to exit the query page. The parameter query page
automatically closes if no button is pressed within the next 60
seconds.
Table 4.3: Indoor unit parameters check list
Check No.
1 IDU address
2 Capacity of indoor unit
3 Actual set temperature Ts
4 Current running set temperature Ts
5 Actual T1 indoor temperature
6 Modified indoor temperature T1
7 T2 heat exchanger intermediate temperature
8 T2A heat exchanger liquid pipe temperature
9 T2B heat exchanger gas pipe temperature
10 Actual set humidity RHs
11 Actual RH indoor humidity
12 Actual fresh air processing unit TA air supply temperature
13 Air-blow pipe temperature
14 Compressor discharge temperature
15 Target superheat
16 EEV opening (actual opening/8)
17 Software version No.
18 Historical error code (recent)
19 Historical error code (sub-recent)
20 [―――] is displayed
Notes:
1. For indoor units, the communication address and network address are the same and are routinely referred to simply as the unit's "address".
2. If use other controllers, please refer to the corresponding manual.
" for 2 seconds to enter the query interface,
Parameters
1
"
Selection
Press and hold the
keys
key for 2s to enter
Remarks
0 - 63
Unit: HP
Unit:℃
Unit:℃
Actual value = value displayed
Actual value = value displayed
Actual value = value displayed
Actual value = value displayed
Actual value = value displayed
Actual value = value displayed
Actual value = value displayed
Actual value = value displayed
Actual value = value displayed
Actual value = value displayed
Actual value = value displayed
Actual value/8 = value displayed
Actual value = value displayed
Actual value = value displayed
Actual value = value displayed
Check No.
Parameters
OK key
Return key
37