Warm-Up Time - Sartorius SECURA1102-1NUS User Manual

Removing the power plug adapter
Press on the ribbed button from above while sliding the power plug adapter
t
backward .
Push the power plug adapter out of the AC adapter and remove it .
t
Connecting the AC Adapter
Check the voltage rating on the AC adapter's type plate . Make sure that the
t
voltage rating printed on this unit matches the local supply voltage at the place
of installation .
If the stated supply voltage does not comply with the local supply voltage or there
t
is no suitable AC adapter available: Do not use the AC adapter . Contact Sartorius
Service .
Only use original Sartorius AC adapters .
t
Connect the angle plug (2) to the device's power supply socket
t
1
(operating voltage connection) .
Connect the power cable (1) to the wall outlet (supply voltage) at the
t
installation location .
2
4.6

Warm-up Time

0 0
y To ensure accurate results are delivered, the balance must warm up for at least
30 minutes after initial connection to the power supply .
Only after this time will the device have reached the required operating
temperature .
30 30
When a verified balance of accuracy class
to the mains power, it must warm up for at least one hour before operation .
Getting Started
for use in legal metrology is connected
k
User Manual Secura ® , Quintix ® , Practum
15
®