Warm-Up Time; Antitheft Locking Device - Sartorius Factory Series Installation Instructions And Safety Information

Connecting Electronic Peripheral Devices
! Make absolutely sure to unplug the scale from AC power before
you connect or disconnect a peripheral device (printer or PC) to or from
the interface port.
! The connecting cables from the scale to the display and control unit,
to the T-connector and to the Zener barrier must be installed so that they
are stationary and protected from damage.
! In the YDI01-Z, YDI02-Z and YDI03-Z Zener barriers, there are 1, 2 or 4
type Z966 Zener barriers. These are designated as [EEx ia]IIC and
can be used in temperature range of 0°C to +40°C (+32°F to +104°F).
The barriers must be installed outside the hazardous area or location and
connected to the equipotential bonding conductor through the terminal
on the housing. Any peripheral devices connected must be incapable of
supplying more than 250 V to the barriers.
! The wiring in the T-connector is passive. The foot switch contains
only a simple switch that sets the "UNIVERSAL_IN" signal to "GND."
Both devices can be used within the Zone 1 or 2 hazardous area or
Class I, Division 1 hazardous (classified) location.
Warmup Time
To deliver exact results, the scale must warm up for at least 30 minutes after
initial connection to AC power or after a relatively long power outage. Only
after this time will the scale have reached the required operating temperature.
To use a verified scale in legal metrology:
$ Be sure to allow the scale to warm up for at least 24 hours after initial
connection to AC power
Covering the Interface Port
If you are not using the interface port, be sure to cover it with the protective
cap supplied with the scale (this is obligatory for using the scale in Zones 1
and 2 hazardous areas and Class I, Division 1 hazardous locations).

Antitheft Locking Device

$ Only for models FC06BBE-SX, FC6CCE-HX, FC2CCE-SX, FC12CCE-SX,
FC6CCE-SX, FC12CCE-IX
To fasten an antitheft locking device, use the lug located on the rear panel
of the scale.
§ Secure the scale at the place of installation, e.g., with a chain or a lock.
Getting Started
13