Lighting And Operation - HearthStone Aurora 8900 Series Owner's Manual

Hide thumbs

Table Of Contents

Table of Contents

Hearthstone Quality Home Heating Products, Inc

WARNING: If you do not follow these instructions exactly, a fire or explosion may

result causing property damage, personal injury or loss of life.

When lighting this appliance, follow these instructions exactly:

A. This appliance is equipped with an ignition device that automatically lights the pilot. Do not try to light

the pilot by hand.

B. BEFORE OPERATING THE BURNER SYSTEM, smell around the appliance area for gas. Be sure to

smell next to the floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

Do not try to light the appliance.

Do not touch any electric switch; do not use any telephone in your building.

Immediately call your gas supplier from a neighbor's telephone. Follow the gas supplier's

instructions

If you cannot reach your gas supplier, call the fire department.

C. Use only your hand to operate the gas controls. Never use tools. If a knob will not push in or turn by

hand, don't try to repair it, call a qualified service technician. Force or attempted repair may result in a

fire or explosion.

D. Do not use this appliance if any part has been under water. Immediately call a qualified service

technician to inspect the appliance and to replace any part of the control system which has been under

water.

OPERATING INSTRUCTIONS

1. STOP! Read the safety information above on this label.

2. This appliance is equipped with an ignition device that automatically lights the pilot. Do not try to light

the pilot by hand.

3. Using the Remote Handset, or the optional Wall Switch, push the "OFF"

audible signal to insure the appliance is Off.

4. Wait five (5) minutes to clear out any gas. Then smell for gas including near the floor. If you smell gas,

STOP! Follow "B" in the safety information above. If you don't smell gas, proceed to step 5.

5. Using either the Remote Handset, or the optional Wall Switch, simultaneously press the "ON"

and "High Flame"

6. Continuing beeps confirm the ignition is in process. Once lighting the pilot flame should appear as

shown in Fig.2. Once the pilot is confirmed, the main burner ignites on high.

NOTE: If the pilot does not stay lit after several tries, proceed to step 9.

7. Use the flame height adjustment buttons on either the Remote Handset or the optional Wall Switch to

adjust the flame. Press the

button twice to increase flame height to the highest setting. Pressing the

module the flame to intermediate settings. The Remote Handset can also be used to control the

appliance thermostatically.