Table of Contents
Advertisement
Hearthstone Quality Home Heating Products, Inc
6. Replace the battery compartment cover. Rotate
the Valve Receiver Module and mounting bracket
into its home position and tighten the thumb
screw to secure.
7. The remote handset is powered by three "AAA"
batteries. The access panel is located on the
back of the handset and simply snaps open to
provide access to the battery compartment.
Install the three batteries as shown on the label
inside the remote control battery compartment.
8. Replace the remote handset access panel.
Placing the Burner Glass Media
The burner glass media poly-bag that you set aside
when you unpacked the fireplace contains the
correct amount of glass material to cover the burner.
The entire contents of the bag should be evenly
distributed over the burner tray.
1. Locate the burner in the fireplace. Refer to the
adjacent illustration.
2. Carefully clip one corner of the poly-bag to form
a pouring spout. The opening should be large
enough to allow the glass media to flow but not
so large that you can't control the flow.
3. You will notice that the burner surface is
designed with turned-up edges that form a tray to
hold the glass media.
4. Starting at one end, pour the glass media onto
the burner tray, keeping the pouring spout on
the poly-bag toward the center of the burner to
avoid spillage of glass pieces over the sides of
the burner. See the adjacent illustrations.
5. Once you have poured all of the glass burner
media into the burner tray, carefully smooth
the glass pieces out so they have a uniform
depth over the entire surface of the burner.
When the burner glass media is properly
placed, it should look like the adjacent
illustrations.
6. Note: If a few pieces of glass escape over the
edges of the burner tray during installation, it is
not a problem. They will simply land in the
area below the burner and will do no harm.
ORION 16 Series 8900
30
Advertisement
Table of Contents
