5-Unpacking - MCZ PLASMA 75Q RH/LH WOOD Instructions Manual

5-UNPACKING

IMPORTANT!
The closed fireplace must be installed and connected to the smoke duct exclusively by a specialised technician, so
that every local or national regulation is observed. Installation must nevertheless be carried out in accordance with
regulation UNI 10683.
When you unwrap the closed fireplace, make sure that every part is in perfect working order or check for any damage due to transport.
Any damage must be immediately reported to the carrier or dealer.
If the closed fireplace is installed in an area of difficult access, its weight can be lightened by removing the internal elements of the
firebox, however it is necessary to put every element correctly back in place and have this operation carried out exclusively by specialised
personnel.
The producer will not be held liable if the above warning is not observed.
PREPARATION AND UNPACKING
Open the packing, remove the closed fireplace from the pallet and place it in the selected position, ensuring it complies with the
specifications.
The closed fireplace must always be carried UPRIGHT and exclusively with a cart. Do not drag the unit as this could
damage the supporting feet.
To remove the closed fireplace from the pallet, do the following:
• Remove plate "s" by taking out the two screws "x"
• Pull plate "s" out from the product's foot.
There are four "s" plates that need to be removed. Pay particular attention to the door and its glass, protecting them from mechanical
knocks that would compromise their integrity.
Products must always be handled with care. If possible unpack the closed fireplace near the place of installation.
The packaging materials are neither toxic nor harmful, therefore no particular disposal measures are required.
The end user is responsible for product storage, disposal or possible recycling in compliance with the relative applicable laws in force.
26
PACKAGING