Daikin Altherma 3 R MT F Series Installer's Reference Manual page 187

ERRA08~12E + ELVZ12S18+23E
Daikin Altherma 3 R MT F
4P708478-1 – 2023.05
# Code
[3.6] [0-04]
[0-05]
[0-06]
[0-07]
Emitter type
For more information about Emitter type, see
# Code
[3.7] [2‑0D]
The setting of the emitter type has an influence on the space heating setpoint
range and the target delta T in heating as follows:
Description
Set weather-dependent cooling:
Note: There are 2 methods to set the weather
dependent curve. See "11.5.2 2-points
4
curve" [ 164] and "11.5.3 Slope-offset
4
curve" [ 165]. Both curve types require 4 field
settings to be configured according to the figure
below.
T t
[0-05]
[0-04]
[0-07] [0-06]
▪ T : Target leaving
t
(additional zone)
▪ T : Outdoor temperature
a
▪ [0-07]: Low outdoor ambient temperature.
10°C~25°C
▪ [0-06]: High outdoor ambient temperature.
25°C~43°C
▪ [0-05]: Desired leaving water temperature
when the outdoor temperature equals or drops
below the low
[9‑07]°C~[9‑08]°C
Note: This value should be higher than [0‑04]
as for low outdoor temperatures less cold
water is required.
▪ [0-04]: Desired leaving water temperature
when the outdoor temperature equals or rises
above the high
[9‑07]°C~[9‑08]°C
Note: This value should be lower than [0‑05] as
for high outdoor temperatures colder water is
required.
"11.6.3 Main
Description
Emitter type:
▪ 0: Underfloor heating
▪ 1: Fancoil unit
▪ 2: Radiator
11 Configuration
|
T a
water temperature
ambient temperature.
ambient temperature.
4
zone" [ 173].
Installer reference guide
187