Powering On The Projector - Barco G50 Installation Manual

Powering On/Off the projector

4.1 Powering On the projector

How to power On the projector
1. Power on the AC switch (1) and wait until the power button on the control panel is solid red.
FOCUS
1
Image 4–1
2. Turn on the projector by pressing the POWER button (2) on the control panel or the ON key (3) on the
remote control.
The status LED (4) will flash orange. The startup screen will display and the status LED will turn to solid
green.
2
Image 4–2
3. Is this the first time that the projector starts up? (First installation or after a factory reset)
► If yes, a popup window appears with the request to accept Barco's End User License Agreement
(EULA). Select CONTINUE to accept the EULA terms and to proceed using the projector. If you do not
accept the EULA terms (CANCEL), the projector will be switched off.
Note: Use the remote control or control panel to select your choice.
Image 4–3
Note: The
4. Turn on your source. The projector detects the source you selected and displays the image.
Note: If you connect multiple input sources at the same time, press the Input key on the control
panel or on the remote control to switch inputs.
46 R5916677 /00 G50
3
EULA can be downloaded from the Barco website.
ZOOM
FOCUS
4