G lens (0.37 - 0.4 : 1) UST 90°
Image 6–4 Left mark on the lens
For left projection, make sure the red dot on the interface is next to the "Left" marking on the lens.
Image 6–5
1
Wire routing
2
Projection orientation : left
90° rotated
To go from the standard position to a 90° rotated position, turn out the eight M3 screws.
Slide the interface a few mm to the backside of the lens.
Rotate the interface 90° until the red dot on the interface is next to the 'Up' mark on the lens body.
Slide the interface back to the front of the lens to re-engage focusing gear and motor gear.
Drive in eight M3 cap screws with some glue.
The lens is ready to be mounted in the projector.
60
R5916677 /00
G50
1
2