Table of Contents
Advertisement
Fixate the adapter plate with 3 screws M4x10 to the lens. To continue, go to step 8.
Image 6–13
6.
For up projection: adapt the lens clamp module. Remove the lens clamp part from the lens clamp module
by removing the 3 screws
screws M4x10
(Image
Image 6–15
7.
Mount the safety bar with 2 screws M4x10 on the side of the lens (reference 1 & 2 in
safety bar will be used to mount the safety cable. To continue, go to step 9
2
1
Image 6–17
8.
Turn the projector up side down and mount the safety bar with 2 screws M4x10. This safety bar will be
used to mount the safety cable.
(Image
6–15. Just mount the lens clamp part on the lens holder module using 2
6–16. Tighten with a torque between 3.5 and 9.8 Nm
G lens (0.37 - 0.4 : 1) UST 90°
Image 6–14
Image 6–16
Image
6–17). This
R5916677 /00
G50
65
Advertisement
Table of Contents
