Table of Contents
Advertisement
G lens (0.37 - 0.4 : 1) UST 90°
Image 6–9
2.
Mount the base plate on the projector beams. Use 4 bolts M6x22 with 4 spring washers M6 and 4 washers
M6 (reference 1 in
Tighten with a torque between 3.5 and 9.8 Nm
When the projector will be used in table mounting configuration, also turn in the four feet (reference 2 in
drawing B).
A
Image 6–10
3.
Install the UST lens. Rotate the UST lens clockwise to lock the lens.
Image 6–11
4.
The lens holder module is preassembled with screws 2 & 3. Start loosen screws 2 & 3 before starting the
next step.
Mount the lens holder module on the base plate with screws with reference 1 and 4 in
them in partially. Use M6x22 screws and insert on each a spring washer M6 and washer M6.
Note: Do not tighten the 4 bolts yet.
Image 6–12
5.
For left projection: mount the lens clamp module on the lens holder module by inserting 2 screws M6x22, 2
spring washers M6 and 2 washers M6. Tighten with a torque between 3.5 and 9.8 Nm
64
R5916677 /00
G50
Image
6–10). Insert the spring washer in between the screw head and the washer.
2
1
1
2
3
4
1
B
Image
6–12. Drive
Advertisement
Table of Contents
