Table of Contents
Advertisement
Powering on/off the projector
5.1 Powering on the projector
How to power on the projector
1.
Power on the AC switch (1) and wait until the power button on the control panel is solid orange.
Image 5–1
2.
Turn on the projector by pressing the POWER button (2) on the control panel or the ON key (3) on the
remote control.
Image 5–2
The status LED (4) will flash orange. The startup screen will display and the status LED will turn to solid
green.
Image 5–4
3.
Turn on your source. The projector detects the source you selected and displays the image.
Note: If you connect multiple sources at the same time, press "Input" key on the control panel or
on the remote control to switch inputs.
If this is the first time you powered up the projector, you will be prompted to select the projector
language, projector orientation and other basic settings.
WARNING: Do not look directly into the lens when the projector is turned on. The strong light might
cause permanent eye damage.
58
R5913458 /01
G100
I
1
0
Image 5–3
Advertisement
Table of Contents
