Powering On The Projector; Powering Off The Projector - Barco G60 Installation Manual

Powering On/Off the projector

3.1 Powering On the projector

How to power On the projector
1. Power on the AC switch (1) and wait until the power button on the control panel is solid red.
Image 3-1
2. Turn on the projector by pressing the POWER button (2) on the control panel or the ON key (3) on the remote
control.
MENU
LENS
FOCUS
Image 3-2
The status LED (4) will flash orange. The startup screen will display and the status LED will turn to solid green.
Image 3-3
3. Turn on your source. The projector detects the source you selected and displays the image.
Note: If you connect multiple sources at the same time, press "Input" key on the control panel or on
the remote control to switch inputs.
WARNING: Do not look directly into the lens when the projector is turned on. The strong light might
cause permanent eye damage.

3.2 Powering Off the Projector

How to power Off the projector
1. Press the POWER button (2) on the control panel or the OFF key (5) on the remote control, a message
displays on the screen.
26 R5910887 /00 G60
1
EXIT INPUT
ENTER
3
ON OFF
1 2 3
4 5 6