Godox V860III-C User Manual page 26

Check the communication channel.
If the Transmitter unit Receiver unit(s) are set to a different channel, set them to
•
the same channel.
Position the camera and flashes
Position the camera and flashes as the picture shows.
•
Set the Transmitter unit's flash mode to <ETT>
Set the Transmitter unit's flash mode to <ETTL>.
•
For shooting <ETTL> will automatically be set for the Receiver unit.
•
Set the Transmitter unit flash firing as ON to fire a flash.
•
Check that the flash is ready
Check that the Transmitter flash ready indicator is lightened.
•
When the Receiver flash ready indicator is ready, the AF-assist beam lighting area
•
will blink at 1 second intervals.
Check the flash operation.
Press the Transmitter unit's Test Button < >
•
Then, the Receiver unit will fire. If not, adjust the Receiver unit's angle toward the
•
Transmitter unit and distance from the Transmitter unit
Using Automatic Wireless Flash with Multiple Receiver Units
When stronger flash output or more convenient lighting operation is needed, increase
the number of Receiver units and set it as a single Receiver unit. To add Receiver units,
use the same steps as setting "automatic wireless flash with a single Receiver unit". Any
flash group can be set (A/B/C/D/E). When the number of Receiver units is increased, and
the Transmitter unit flash firing is ON, automatic control is implemented to make all
groups of flashes fire the same flash output and ensure the total flash output up is to
standard exposure.
26