Page 2
Always keep this product dry. Do not use in rain or in damp conditions. This V860IIS camera flash applies to Sony DSLR series cameras Do not disassemble. Should repairs become necessary, this and is compatible with TTL autoflash. With this TTL compatible product must be sent to an authorized maintenance center.
Warning Name of Parts Body Control Panel LCD Panel What's in the Box of V860IIS Kit? What's in the Box of V860IIS (only flash unit)? Separately Sold Accessories Battery Attaching to a Camera Power Management Flash Mode: TTL Autoflash FEC (Flash Exposure Compensation)
2. Do not expose to rain or immerse into water. This battery is not water proof. ● What’s in the Box of V860IIS (only flash unit)? 3. Keep out of reach of children. 4. No over 24 hours’ continuous charging.
To unload the battery, tap the C.Fn Disabling Auto Power Off function is recommended white knob and the battery when the flash is used off camera. (C.Fn-APO, Page 49) pack will pop out. Then close Slave Auto Power Off Timer is set to 60 minutes by C.Fn the compartment.
High-Speed Sync Optical S1 Secondary Unit Setting High Speed Sync (HSS flash) enables the flash to synchronize with In M manual flash mode, press <S1/S2> button so that this flash can all camera shutter speeds. This is convenient when you want to use function as an optic S1 secondary flash with optic sensor.
Slave/Master Unit’s Positioning and Operation Range To avoid overheating and deteriorating the flash head, do not use stroboscopic flash more than 10 times in succession. 15m(49.2ft) After 10 times, allow the camera flash to rest for at least 15 Indoors minutes.
● Even with multiple slave units, the master unit can control Exit Optical Wireless Lighting Mode all of them via wireless. Set the camera to NON ● In this user manual, “master unit” refers to the camera flash wireless lighting mode. on a camera and “slave unit”...
Slave Unit Setting ● Flash Exposure Compensation ( / Page 36) ● Set the V860IIS that to be About Master Unit controlled as the wireless Use two or more master units. By preparing several cameras that slave unit.
Using a flash (master/slave) with a radio transmission wireless Function Radio Transmission Optical Transmission shooting function make it easy to shoot with advanced wireless Distance 100m multiple flash lighting, in the same way as TTL autoflash shooting. The basic relative position and operation range are as shown in the Channel 1~32 picture.
Bounce Flash ZOOM: Setting the Flash Coverage and Using By pointing the flash head toward a wall or ceiling, the flash will the Wide Panel bounce off the surface before illuminating the subject. This can The flash coverage can be set automatically or manually. It can be soften shadows behind the subject for a more natural-looking shot.
C.Fn: Setting Custom Functions Protection Function The following table lists the available and unavailable custom 1. Over-Temperature Protection functions of this flash. To avoid overheating and deteriorating the flash head, do not fire ● more than 30 continuous flashes in fast succession at 1/1 full C.Fn Custom Functions power.
Technical Data Troubleshooting If there is a problem, refer to this Troubleshooting Guide. Model V860IIS • Type The Camera Flash cannot be charged. Compatible Cameras Sony DSLR cameras (TTL autoflash) ● The battery is installed in the wrong direction. Guide No.
Firmware Upgrade This flash supports firmware upgrade through the USB port. Update information will be released on our official website. USB connection line is not included in this product. The USB port is a standard Micro USB socket. Common USB connection line is applicable.
Page 16
FCC Warning This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Need help?
Do you have a question about the V860IIS and is the answer not in the manual?
Questions and answers