Godox V860III-C User Manual page 14

ETTL Mode
Press <MODE> Mode Selection Button to enter E-TTL mode. The mode LCD panel will
display.
Press the camera release button halfway to focus. The aperture and effective
•
flash range will be displayed in the viewfinder.
When the shutter button is fully pressed, the flash will fire pre-flash that the
•
camera will use to calculate exposure and flash output the instant before the
photo is taken.
FEC: Flash Exposure Compensation
With FEC function, this flash can adjust from -3 to +3 in 1/3 stops. It is useful in situations
where minor adjusting of the TTL system is needed based on the environment.
FEC Setting:
Press Function Button 2
Press the <+/-> button. The
< > and flash exposure
compensation amount will
be highlighted on the LCD
panel.
FEB: Flash Exposure Bracketing
You can take three flash shots while automatically changing the flash output for each
shot from -3 to +3 in 1/3rd stops. The camera will record three images with different
exposures: one exposed according to camera calculations, one over-exposed and
another under-exposed. Over and under exposure amount is user adjustable. This
function helps get correct exposure especially in shooting moving objects or when
environmental lights are complex.
Set the flash exposure
compensation amount.
Turn the Select Dial
•
to set the amount.
"0.3" means 1/3
•
step, "0.7" means
2/3 step.
To cancel the flash
•
exposure
compensation, set
the amount to "+0".
14
Press Set Button again to
confirm the setting.