Verifying The Rpo Port Connection - HPE G2 R5000 3U User Manual

Main menu
Settings
Event log
Fault log
Identification
Register product

Verifying the RPO port connection

NOTE: While testing, operate connected equipment in a safe test mode so the effects do not disrupt critical operations.
Prerequisites
Connect the RPO port.
Procedure
1. Initiate an RPO by closing the RPO contact.
2. Verify proper connection of the RPO port.
a. Power up the UPS by pressing the Power button.
b. Disconnect the RPO port.
c. Reconnect the RPO port.
d. Verify that the UPS remains in Online mode.
Submenu Display information or menu function
Reset average Clears average power usage measurement
power
Reset cumul. power Clears cumulated power usage measurement
Dry contacts test Tests dry contact relay outputs
Local settings Sets product general parameters
In/Out settings Sets output parameters
On/Off settings Sets on/off conditions
Battery settings Sets battery configuration
Event filter Selects faults, alarms, and events to display
Event list Displays the events stored
Reset event list Clears events list
Fault list Displays the faults stored
Reset fault list Clears faults list
— Product type, serial number, UPS firmware, communication card IPv6,
communication card MAC, detected accessories
— Links to the HPE registration website
30
Operations